Need to do a little reinforcing to the floor!
|
|
|
I start out by digging up some spots and leveling some 1" X 4" frames I made.
|
|
|
I used a 2" X 12" to run across 7 joist, this will make the wieght distribution span across all 7 of the joist rather than just the 4 the tank mainly sits on.
|
|
|
All forms are in place and ready for the cement to be poured.
|
|
|
Pads poured and the blocks are set in place ready for the 4" X 4" that will be supporting the floor.
|
|
|
The 4"X4"'s are in place and doin there job!!
|
|
|
You can see here where I used shims to tighten the fit between the 2"X12" and the 4"X4", this ensures that if there are any fluctuations in the cement pads I layed I can use the shims to tighten the fit.
|
|
|
Wide angle of the shims, the 2"X12", and the extra steel bracing I installed.
|
